G4X PlugIn ECUs offer the latest in engine management technology, designed to easily maximize the potential from your car. This ECU fits inside the factory OEM enclosure. Installation is a breeze, with no alteration of the factory wiring loom required for the models listed below. Designed for the 1JZ-GTE (Non-VVTi) engine.

• Please check your connector matches the header in the listed photo before purchasing.
• This ECU works for manual transmissions only.
• ECU includes an onboard 7 bar MAP sensor.
• Most factory features are supported. Check the features tab for I/O expansion options

Suitable applications:

• Toyota JZX90 (Chaser/Cresta/Mark II) with 1JZ-GTE (Non-VVTi) engine, Manual Transmission
• Toyota JZZ30 (Soarer) with 1JZ-GTE (Non-VVTi) engine, Manual Transmission

Note: This Plug-in features a new 4 pin powered CAN connector and cannot use the old CANPCB cable for CAN connection. Use the CANJST4 (Link PN 101-0198) cable for connecting CAN devices. This new 4 pin port and cable provide not only the CAN connection, but also a protected 12V power supply and ground for powering the CAN devices. The power supply is protected by a self-resetting fuse rated at 3A continuous.     G4X PlugIn Key Features (where applicable):

• Up to 6D fuel and ignition mapping
• Precision closed loop cam control (four cam, independent control)
• Sequential fuel delivery
• Digital triggering, all OEM patterns
• OEM idle hardware supported
• 5D boost control with three switchable tables
• Motorsport features - antilag, launch, flat shift
• Continuous barometric correction (on board)
• CAN port
• QuickTune - automated fuel tuning
• Individual cylinder correction
• USB tuning cable included
• Stats recording into on-board memory
• Gear compensations for spark, boost and fuel
• Real time selectable dual fuel, ignition and boost maps
• Sync and crank sensors can be a combination of Hall effect, variable reluctance or optical
• Boost control referenced to gear, speed or throttle position
• 512 mega bytes data logging memory
• Staged injection
• Knock with "windowing"

I/O Expansion Options: The following expansion connector inputs/outputs are provided: Expansion Connector 1 (J3) Pin 1 Ground (signal) Pin 2 5v out Pin 3 Injector 4 Pin 4 Injector 5 Pin 5 Injector 6 Pin 6 AUX 4 Pin 7 AN TEMP 4 Pin 8 AN TEMP 3 Expansion Connector 2 (J9) Pin 1 Ground (signal) Pin 2 5v out Pin 3 DI7 Pin 4 DI8 Pin 5 DI9 Pin 6 An Volt 8 Pin 7 An Volt 9 Pin 8 An Volt 10 E-Throttle Connector (J5) Pin 1 Ground (signal) Pin 2 5V out Pin 3 An Volt 4 Pin 4 An Volt 5 Pin 5 An Volt 6 Pin 6 An Volt 7 Pin 7 Aux 10 Pin 8 Aux 9